Micro Machines
Micro Machines
 |
 STAR WARS MICRO MACHINE SOTE VIRAGO GALOOB LOOSE  US $5.99
|
 STAR WARS MICRO MACHINE AT-AT GALOOB LOOSE US $4.99
|
 STAR WARS MICRO MACHINE SAIL BARGE GALOOB LOOSE US $4.99
|
 STAR WARS MICRO MACHINE SITH INFILTRATOR GALOOB LOOSE US $4.99
|
 STAR WARS MICRO MACHINE MILLENNIUM GALOOB LOOSE US $4.99
|
 STAR WARS MICRO MACHINE ATT US $4.99
|
 STAR WARS MICRO GALOOB DROID LOT GONK & MOUSE LOOSE US $4.99
|
 STAR WARS MICRO MACHINE R5-D4 DROID LOOSE US $3.99
|
Casting is a process of forming metal products by melting metal and pouring it into a hole know as mold and allowed refrigerate it, there are several methods such as gravity casting or permanent mold casting, slush casting, pressure or corthias castings, die casting machines, hot room, cold room machines, centrifugal castings, semi-centrifugal casting. Precision castings lost wax casting method, Plaster molds, Shell molding, mold forests, rubber and paper.
In this article we will discuss the advantages and dis-advantages of the casting process DIE.
The advantage of Sun Casting
A) very high rates of production are possible, ie, room type cold 75-150 units per hour and type of hot room 300-350 units per hour.
2) Close dimensional control can held at Zinc, a tolerance of + / - 0.075 mm to 25 mm size and + / - 0.025 mm for each additional 25 mm can be achieved easily.
3) thin section can be cast in the cast favorable conditions with minimum thickness are about 0.5 mm to 0.875 mm for zinc and aluminum.
4) Surface finish of 1250 mm micro-RMS can be so improved appearance and finishing operation are minimized.
5) Details can be successfully reproduced with a high degree of accuracy.
6) Sun Casting keep dying their accuracy and usefulness for long, crave connections zinc can produce more than 5 million castings.
7) For the mass production of casting dead is very economical due to the elimination of machining and mold, resulting in preservation work and time.
For because of uniformity in wall thickness less material is needed than die casting sand casting.
9) No opportunity sand inclusions and a strong structure of dense metal is taken.
Sun damage castings
1) high cost of equipment and dies used requires very large quantities to compete economically with other processes, die casting for minimum economic considered for many manufacturing 20,000 pieces.
2) There is rapid decline in the life of the metal temperature falls.
3) In some cases there is an unwanted chilling effect on metals.
4) Metals having high coefficient of contraction must be removed the mold as soon as possible due to inability to contract with the casting mold.
5) There is a limit certain form of die castings and the process is not intended for production of large castings, cast so far the maximum size is 100 kg and 30 kg zinc in aluminum.
6) Sun castings usually contain some porosity due to entrapping air.
7) Sun casting has, to a large extent, been restricted to lower non-melting alloys of iron.
Improving gradual heat resisting metal dies, this process can now be used for multiple connections.
In addition you also can use some online calculator engineering in Calculatoredge.com
To calculate the amount of material
To calculated temperature furnace
To calculate the weight throw
To calculate casting Area
To calculate throw Pressure equipment.
You can see this on target = "_blank" rel = "nofollow" www.calculatoredge.com>